Our macerators and gray water pumps are designed for various types of applications. Therefore, they are exposed to different situations such as power failures, occasional abuse, or build-ups of limescale deposits in older units (if not regularly descaled) which can cause a surcharge of water in the unit.
The SaniALARM has a level pressure switch that triggers an alarm fixed on the top of the unit if the volume of water exceeds the maximum allowed level. The alarm emits a continuous 80 dB warning sound until it is switched off or the problem is rectified.
The SaniALARM is battery operated and can be installed on most models* in the Saniflo range, including SaniPLUS and SaniVITE pumps. It has been designed to be installed on new or existing Saniflo installations as it is quickly fitted onto the lid of the Saniflo unit.
Install this top-mounted alarm in a few simple steps: 1) use a 5mm drill bit to place a guidance hole, and then gradually use a 10mm bit to drill the insertion hole. 2) pinch the plunger tube and gradually fit it through the hole until its flange rests on the top of the lid. 3) use some silicone to create a tight seal (optional) 4) push the pressure controller into the plunger tube until the alarm box makes contact with the top of the lid.
Works with Most Saniflo Models
This alarm accessory is suitable for use with all the models in the SaniPLUS, SaniPRO, SaniBEST, SaniGRIND, SaniPACK and SaniVITE product lines. The lids are labeled with faint 'alarm' lettering to indicate the optimum point for drilling/installation.
The unit is powered by two 1.5 V batteries and requires no additional power input
NOTE: Saniflo recommends using a SaniAlarm for all behind the wall pump installations.
Warranty: 2-Year Full Manufacturer Warranty
*Suitable for use with SaniPLUS, SaniPRO, SaniBEST, SaniGRIND, SaniPACK and SaniVITE.